Steam the Weeds Away
Warranty Information
FAQs
The DynaSteam generates a large amount of steam; which can condense into water in the hose, tools, or nozzle and accumulate after a period of cooling/non-use. A small amount of water will be discharged before steam resumes. This is normal, and the excess water can be quickly released into a bucket if the water is unwanted.
Check hose for any kinks or twists and untwist hose, if necessary. You can also check to see if you have run out of water. (Pressure gauge will show zero pressure).
Make sure the DynaSteam is fully depressurized. The pressure cap is designed not to be able to be removed while under pressure. Release all remaining steam in tank by squeezing the Steam Release Trigger, which can be locked open by engaging the Steam Trigger Lock in the ON position. After pressure is released from tank (and allowing a few moments to cool down), the fill cap will be able to be removed.
Any condensation that may appear will evaporate and disappear in a short time. No action is required.
A small blockage caused by dirt or other foreign substance may be preventing the smooth flow of steam. Cleaning the tank thoroughly should alleviate this issue.
No. Boiled water concentrates the minerals that form lime scale. Never use pre-boiled water in the DynaSteam.
No. Water left in the boiler for a prolonged period may deteriorate the mechanics of the DynaSteam. Never leave water in the DynaSteam; always empty after using. If you have hard water/high mineral content in your tap water, we recommend using distilled water to extend the life, and enhance the performance of your DynaSteam.
For maximum killing power, most weeds require the steam temperature to be in the red zone. If the needle falls below the red zone, pause for a moment and allow DynaSteam to recover before resuming.
Push green button down on Steam Handle and slide on extension wands/accessories. Make sure button pops up to Lock accessory in position before using.
If your water source contains high mineral content we recommend using distilled or demineralized water in your DynaSteam. If you must use water with a high mineral content, we recommend following the cleaning process below.
To clean your water tank and remove mineral buildup, follow the procedure below:
(Do not use detergent for cleaning the tank)
- Mix a 50/50 solution of 8 oz. vinegar with 8 oz. of water in a measuring cup.
- Pour the solution into a cool and unheated tank, using the funnel.
- Let solution soak in tank for approximately 30 minutes.
- After 30 minutes, empty the solution from the tank.
- Repeat steps 1 through 5 if necessary.
- Rinse thoroughly with water.
- Replace pressure cap and store in a safe, dry location.
LIMITED WARRANTY: Woodstream (formerly DYNAMIC) warranties to the original purchaser that this product is free from defective materials and workmanship. This warranty is limited to remedy any defective part for a period of one year from original date of purchase. Retain your original receipt as proof of purchase. This warranty does not apply to, in our judgment, misuse or abuse. If this unit has been altered, no warranty is in force. This warranty does not apply if this unit is purchased outside the United States, Canada and Mexico. In no case shall Woodstream (formerly DYNAMIC)be liable for any accidental, punitive, consequential, or any other damages of any kind for breach of this or any other warranty, expressed or implied, whatsoever. Some states do not allow limitation on how long an implied warranty lasts, so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other rights that vary from state to state.
Register Your Product Online Here
To obtain warranty service during the warranty period, contact Woodstream here for a Return Authorization Number (RA#).